On Mon, 10 Aug 2026, Viesturs L?cis wrote:
pirmd., 2026. g. 10. aug., plkst. 23:20 ? lietot?js Peter Wallace
(<[email protected]>) rakst?ja:
Also make sure W10 is in the down position
Just to make sure I am not missing anything (because it is almost
midnight here) - in picture and in manual W10 is in UP position and I
should move it to DOWN position?
It should not matter, just trying to minimize variables
Can you remind me of the firmware used?
I'll try and duplicate your setup here
Thank you! It is flashed with 5i24_16_svss8_8.bit.
Viesturs
Well.. as expected, I cannot duplicate your issue...
LinuxCNC 2.9.10
6I24_16 with 5i24_16_svss8_8.bit firmware
LinuxCNC runs normally with changing PWM outputs
Older Dell Desktop (Optiplex 9020)
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
Peter Wallace
Mesa Electronics
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
