otrd., 2026. g. 11. aug., plkst. 00:25 — lietotājs Peter Wallace (<[email protected]>) rakstīja: > > > Well.. as expected, I cannot duplicate your issue... > > LinuxCNC 2.9.10 > > 6I24_16 with 5i24_16_svss8_8.bit firmware > > LinuxCNC runs normally with changing PWM outputs > > Older Dell Desktop (Optiplex 9020) >
I will check the jumpers, set W2 in UP and W10 in DOWN position and retry. If that doesn't work, I suppose I will take this setup back home and try 6i24 board in my other PC. Strangely enough this was something I could have tested beforehand... I will report back when I have any new findings. Viesturs _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
