You could try setting up net console and look if the kernel outputs something interesting before the PC is rebooting.
https://www.croit.io/blog/how-to-capture-kernel-panic-messages-with-netconsole Am Dienstag, dem 11.08.2026 um 08:28 +0300 schrieb Viesturs Lācis: > otrd., 2026. g. 11. aug., plkst. 00:25 — lietotājs Peter Wallace > (<[email protected]>) rakstīja: > > > > > > Well.. as expected, I cannot duplicate your issue... > > > > LinuxCNC 2.9.10 > > > > 6I24_16 with 5i24_16_svss8_8.bit firmware > > > > LinuxCNC runs normally with changing PWM outputs > > > > Older Dell Desktop (Optiplex 9020) > > > > I will check the jumpers, set W2 in UP and W10 in DOWN position and > retry. > > If that doesn't work, I suppose I will take this setup back home and > try 6i24 board in my other PC. > Strangely enough this was something I could have tested beforehand... > > I will report back when I have any new findings. > > Viesturs > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
