Here it is.
# ethercat config -v
Alias: 0
Position: 0
Vendor Id: 0x00000002
Product code: 0x04570862
Attached slave: 0 (OP)
SM0 (Output)
Pdo 0x1a00
Pdo entry 0x3101:01, 8 bit
SM1 (Output)
Pdo 0x1a01
Pdo entry 0x3101:02, 8 bit
SM2 (Input)
Pdo 0x1600
Pdo entry 0x3001:01, 8 bit
Pdo 0x1601
Pdo entry 0x3001:02, 8 bit
Sdo configuration:
None.
Regards,
Hobin Yoon
On Tue, Dec 9, 2008 at 6:25 PM, Florian Pose <[EMAIL PROTECTED]> wrote:
> On Tue, Dec 09, 2008 at 06:11:10PM +0900, Hobin Yoon wrote:
> > # ethercat slave -v
> > === Slave 0 ===
> > ...
>
> Ok, the slave does not support CoE, so the PDOs can not be configured by
> the master.
>
> > # ethercat config -v
> > (nothing... correct?)
>
> Sorry, this is only applicable with a loaded application. Could you
> repeat that?
>
> --
> Best regards,
> Florian Pose
>
> http://etherlab.org
> _______________________________________________
> etherlab-users mailing list
> [email protected]
> http://lists.etherlab.org/mailman/listinfo/etherlab-users
>
_______________________________________________
etherlab-users mailing list
[email protected]
http://lists.etherlab.org/mailman/listinfo/etherlab-users
