I don't understand the procedures to set up the IOCP/OS configurations in order to have my Test and Prod lpars using the same IOCP in slot A3. Do I need an card such as: * Column Contents * ---------- ---------------------------------------------- * 1 - 8 LPARNAME * 10 -17 A required logical partition name as defined to LPAR. * A blank indicates an OS/390 image not running in LPAR * mode. The default of matching the system being IPLed * is set indirectly by specifying the HWNAME parameter. in order to get this to work and should I define an Prod & Test configuration in the IOCP gen with HCD. I have one sitting out there now called OS390 but only my Test lpar can see and use it. Thanks.
Ed Finnell <[EMAIL PROTECTED]> wrote: In a message dated 7/2/2006 2:26:27 P.M. Central Standard Time, [EMAIL PROTECTED] writes: How do I generate 2 OS configurations, one for test and one for prod lpars to use IODF05. Any help will be greatly appreciated. >> LOADxx specifies parms for IODF and a volser. IODF does not have to be CATLOG'ed for IPL but does for DYNAMIC activation. You also said DASD was not shared between test and production. What I'd do is backup IODF05 from test to tape and restore it to PROD on the same volser as current. Then I'd try DYNAMIC activation on PROD for the cataloged version of IODF05 with TEST option and see what happened? ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html --------------------------------- How low will we go? Check out Yahoo! Messengers low PC-to-Phone call rates. ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [EMAIL PROTECTED] with the message: GET IBM-MAIN INFO Search the archives at http://bama.ua.edu/archives/ibm-main.html
