I have obtained new burners for my original "Princes" stove because the
original owner had replaced them with something else.  Pressurized alcohol
works fine, once you learn not to put too much into the preheat cup, and its
safer than other liquids because you can put out an alcohol fire with water.
Having seen the decks of 2 large sailboats removed by propane explosions in
the Portland OR area, I would not consider propane on a boat.

 

  _____  

From: [email protected] [mailto:[email protected]] On Behalf Of John
Gilmore
Sent: Tuesday, June 16, 2009 7:03 AM
To: [email protected]
Subject: Re: [IC27A] Galley stove top

 






Hi,

 

 I am still working on my manifold gasket dilemma, and hope to have the new
bolts tapped out today, but have been following this post regarding Galley
stove tops. I am new tio the C-27 group(73-hull 929)  so I am fired up(no
pun;lol) and ready to get into everything at once lol. Have any of you kept
the original stove? Should I be concerned about trying to get it working? I
have not taken much of a look at it yet, but believe I have the p-22a as I
have noticed the stainless steel lid with cutting board on top. My stove
looks to be in decent condition; however being a camper and dealing with the
good ol colman set-ups for years I know that looks can be very deceiving
lol.  The only thing I notice off the bat was that the left burner knob is
stuck (I have not tried to force it at all) It appears to have a spring
shaft which rotates the burner/fuel control valve so I am thinking I will
need to free it up from sitting. I would imagine this stove was decent for
the time, and being one whom appreciated "the originals" lol  I think it
would be cool to get it working, unless there is a safty reason why I should
not. Any thoughts?

 

 

Thanks,

 

John.

 


 

 

  _____  

From: Don Brooks <[email protected]>
To: [email protected]
Sent: Tuesday, June 16, 2009 9:05:47 AM
Subject: Re: [IC27A] Galley stove top




My boat also had a CNG stove and I did not like it for all the reasons John
mentioned.  I looked into changing over to propane, but to do it right would
require a vented locker and solenoid valve and switch panel.  The cost
started to add up.  I got a new Origo 3000 on ebay for $240.  I did not
gimbal it since we rarely cook under way, unless the conditions are VERY
light.  On the average we use 2 quarts on alchol each year, so I always keep
a spare quart under the galley counter.  Cooking time is about the same as
CNG.  It is simple, safe and most of all, the chief cook loves it.

Don, #6293, Niceville, FL 

 

  _____  

From: The Emmerichs <[email protected]>
To: [email protected]
Sent: Monday, June 15, 2009 9:30:29 PM
Subject: RE: [IC27A] Galley stove top

My boat came with a CNG (compressed natural gas) stove.  While this is a
safe system (CNG is lighter than air so it rises) , I had two problems with
the system:

 

CNG is not available in Louisville, KY.  I would have to go to either
Evansville or Indianapolis, IN to refill the tank.

The CNG tank was installed in the lazereatte(sp) and I didn't feel I needed
all that weight in the aft end of the boat.

 

I did not want to have to deal with propane in the boat.  I have a gas grill
but don't mount it on the rail unless we are going overnight and will use
it.  I realize that issues with leaking propane tanks are very rare but....

 

So, I installed an Origo 3000 and have been very happy with it.  Yes, it was
more expensive but I can sleep better.  I'm probably too paranoid but there
is always the anchor to worry about.

 

John Emmerich

5874 TR

Louisville, KY

 

From: ic...@yahoogroups. com [mailto:IC27A@ yahoogroups. com] On Behalf Of
Bill Pellegrino
Sent: Monday, June 15, 2009 3:23 PM
To: ic...@yahoogroups. com
Subject: RE: [IC27A] Galley stove top [1 Attachment]

 

[ <http://us.mg3.mail.yahoo.com/dc/blank.html?bn=1277.43&.intl=us#TopText>
Attachment(s) from Bill Pellegrino included below] 



Hi Bryan,
 
I converted the original Pressure Alcohol stove into a new propane stove for
under $50 on Aquadesiac.  
 
I bought a new camping stove from Harbor Freight and I installed the burner
eliments into the old stove.  It was an easy conversion and the stove looks
like it was made at the factory.
 
 http://www.harborfr eight.com/ cpi/ctaf/ Displayitem.
<http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=35559>
taf?itemnumber= 35559
 
Good luck and Happy Sailing.

Bill Pellegrino _/)
SV Aquadesiac #5705
Port Edgewood, RI

 

  _____  

To: ic...@yahoogroups. com
From: brype...@yahoo. com
Date: Mon, 15 Jun 2009 16:33:12 +0000
Subject: [IC27A] Galley stove top



I need to replace the propane galley cook top. Any recommendations? There is
a drawer below so the gimbaled version probably wont be practical anyway...

Thanks,

Bryan
Mukilteo, WA





 







E-mail message checked by Spyware Doctor (6.0.1.441)
Database version: 6.12610
http://www.pctools.com/spyware-doctor-antivirus/
<http://www.pctools.com/en/spyware-doctor-antivirus/> 





E-mail message checked by Spyware Doctor (6.0.1.441)
Database version: 6.12620
http://www.pctools.com/en/spyware-doctor-antivirus/

Reply via email to