Not bad for a first print. The Creality CR-10 can give good results. It looks like your may not have enough retraction set in the slicing software which can result in the oozing that you are seeing on your print. Hot end temp may be slightly too high which can also cause oozing. There is a great little test block I use to quickly check filament and settings changes. It is at thingiverse.com at https://www.thingiverse.com/thing:2253091 If the layers delaminate, the hot end temp is too low. If the bridging sags, the hot end temp is too high, or you don’t have sufficient cooling on the job. If you see ‘ripples’ in the vertical sides, the drive belts need tightening, or tolerances on the X/Y axis are sloppy. If you see stringing, try more retraction. Shapeways may be better if you are in the US, but where’s the fun and satisfaction compared to printing your own creations 😊
From: M100 <[email protected]> On Behalf Of Brian White Sent: Thursday, 29 August 2019 9:20 PM To: [email protected] Subject: [M100] pcb2molex8878 Astonishingly, I was just able to print a functional carrier in PLA on a Creality CR-10S. (A very common home $400 fdm printer from a year ago.) I got the printer last year but only opened the box a couple days ago and this is only my 3rd attempt to print anything at all. The carrier looked like crap on the print bed, but after a little manual clean-up, it turned out to actually work! So, these things can be printed at home after all. (scroll to bottom) https://photos.app.goo.gl/zynHU4LSpd5BZBYC9<https://eur04.safelinks.protection.outlook.com/?url=https%3A%2F%2Fphotos.app.goo.gl%2FzynHU4LSpd5BZBYC9&data=02%7C01%7C%7Ca8fddd06ba5748b0d0ed08d72c621630%7C84df9e7fe9f640afb435aaaaaaaaaaaa%7C1%7C0%7C637026672095133352&sdata=QVjMP%2FJwbG25uo9qKbfsVqk9315KHYRjzD8OZHnvIAw%3D&reserved=0> Although, for $5, the Shapeways output is way better. -- bkw
