Hi Brian, This link does not seem to work. Can you set that up again? thx Steve
On Thu, Aug 29, 2019 at 12:55 PM Brian White <[email protected]> wrote: > I definitely prefer the 30 minute turn around time vs a week or three. > > Thanks for the hint with that calibration object. That's exactly the kind > of thing I don't know yet. > > I will avoid getting into actual Cura settings here :) > > I did manage to figure out how to get Sculpteo set up with a sharable > purchase link like Shapeways. They have a very similar set of material, > color, and quality options like Shapeways, except they have offices all > over the world. > > > https://www.sculpteo.com/en/print/pcb2molex8878_chamfer_rex_bkw_c11/foSfeAyj > > -- > bkw > > On Thu, Aug 29, 2019, 5:41 AM Gary Hammond <[email protected]> wrote: > >> Not bad for a first print. The Creality CR-10 can give good results. >> >> It looks like your may not have enough retraction set in the slicing >> software which can result in the oozing that you are seeing on your print. >> Hot end temp may be slightly too high which can also cause oozing. There is >> a great little test block I use to quickly check filament and settings >> changes. It is at thingiverse.com at >> https://www.thingiverse.com/thing:2253091 >> >> If the layers delaminate, the hot end temp is too low. >> >> If the bridging sags, the hot end temp is too high, or you don’t have >> sufficient cooling on the job. >> >> If you see ‘ripples’ in the vertical sides, the drive belts need >> tightening, or tolerances on the X/Y axis are sloppy. >> >> If you see stringing, try more retraction. >> >> Shapeways may be better if you are in the US, but where’s the fun and >> satisfaction compared to printing your own creations 😊 >> >> >> >> *From:* M100 <[email protected]> *On Behalf Of *Brian >> White >> *Sent:* Thursday, 29 August 2019 9:20 PM >> *To:* [email protected] >> *Subject:* [M100] pcb2molex8878 >> >> >> >> Astonishingly, I was just able to print a functional carrier in PLA on a >> Creality CR-10S. (A very common home $400 fdm printer from a year ago.) >> >> >> >> I got the printer last year but only opened the box a couple days ago and >> this is only my 3rd attempt to print anything at all. >> >> >> >> The carrier looked like crap on the print bed, but after a little manual >> clean-up, it turned out to actually work! >> >> >> >> So, these things can be printed at home after all. >> >> >> >> (scroll to bottom) >> >> https://photos.app.goo.gl/zynHU4LSpd5BZBYC9 >> <https://eur04.safelinks.protection.outlook.com/?url=https%3A%2F%2Fphotos.app.goo.gl%2FzynHU4LSpd5BZBYC9&data=02%7C01%7C%7Ca8fddd06ba5748b0d0ed08d72c621630%7C84df9e7fe9f640afb435aaaaaaaaaaaa%7C1%7C0%7C637026672095133352&sdata=QVjMP%2FJwbG25uo9qKbfsVqk9315KHYRjzD8OZHnvIAw%3D&reserved=0> >> >> >> >> Although, for $5, the Shapeways output is way better. >> >> >> >> -- >> >> bkw >> >
