Hi Simon, You might find this helpful: http://www.machinekit.io/docs/getting-help/
Seems like you posted the entire log. That's not increasing the chance you get answers because people would have to do the searching for you. > On 18 May 2017, at 19:05, Simon Mali <smal....@gmail.com> wrote: > > Hello Klemen > Thank you for your answer. Regarding: > 1. I did not see any errors in the linuxcnc.log regarding execution of this > G1 command. Please see the file in attachment. The latest test is dated today > around 18:00. It is the last printout in this file. > Best regards > Simon Mali > > Dne sreda, 17. maj 2017 11.38.16 UTC+2 je oseba Klemen Zhivko napisala: >> >> 1. there should be some error in linuxcnc logs? have you checked those? >> 2. dont know I run my machine over machinekit remote interface (haltalk) >> 3. there is a NO_FORCE_HOMING = 1 in [TRAJ] section in INI >> >> regards >> >> Dne nedelja, 14. maj 2017 15.03.56 UTC+2 je oseba Simon Mali napisala: >>> >>> Dear all >>> After integrating BBB Machinekit into my CNC machine some problems came to >>> surface which I dont know how to solve: >>> >>> 1. Problems with executing some G code file. Both G code files are >>> attached. The problem seems to be the same for both files: while executing >>> the G code machine stops at G1 move, in both files at line N110. There >>> should be no problem with both files (g code) because when I am executing >>> it on my other machine (non LinucCNC, non BBB-machinekit) everything works >>> as expected. I have downloaded the latest application software with apt-get >>> dist. >>> >>> 2. Sometimes the screen resolution changes without the reason. I am turning >>> my machine down when all the blue LED diodes on BBB are off. How to set >>> this screen resolution to always high resolution? I mean when the system >>> boot up, usually after turn off, it boots in low resolution mode. Then I >>> make a restart and after that everything is ok, the system starts in high >>> resolution mode. >>> >>> 3. How to run the machine with G code without homeing it? >>> >>> I hope that somebody can help me with this questions >>> Best regards >>> Simon Mali > > -- > website: http://www.machinekit.io blog: http://blog.machinekit.io github: > https://github.com/machinekit > --- > You received this message because you are subscribed to the Google Groups > "Machinekit" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to machinekit+unsubscr...@googlegroups.com. > Visit this group at https://groups.google.com/group/machinekit. > For more options, visit https://groups.google.com/d/optout. > <linuxcnc.txt> -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to machinekit+unsubscr...@googlegroups.com. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.