thought i was on my way but can't get hot end or bed heater to turn on am
using the remapped m codes i have found for the machinekit 104 and 109
tried all i can think of but no heaters turning on, is m67 and m68 built
into machinekit i don't see any remapped m code for these mcodes
or is there a better way to write the mcodes ? anyone have a working
example? I get no errors when i try to run them.
example of the 104
o<m104> sub
#500=2; extruder io start index
#501=0; not synchronized
#502=#500
o100 if [EXISTS[#<i>]]
o110 if [#<i> EQ 1]
#501=0
o110 endif
o100 endif
o101 if [EXISTS[#<t>]]
#502=[#<t>+#500]
o101 endif
o102 if [#501 EQ 1]
M67 E#502 Q#<P>
o102 else
M68 E#502 Q#<P>
o102 endif
o<m104> end sub
Thanks gary
On Saturday, January 6, 2018 at 8:42:16 PM UTC-5, gary wrote:
> I just connected a BBB and Cramps board to my delta printer, but i have
> been having homing problem
> I have optic switches installed if i go into the hal configuration when
> machinekit it booted, and then to the show window with xmax ymax and zmax
> displayed then when axis's are off the switches there red, and when i
> trigger the switches they turn yellow
> So i assume the switches are working and being read by the software.
>
> But when i do home all the motors they move up to the switches in the
> correct direction but never stop just keeps running into the optic
> end stops and i have to power down..
>
> any suggestions?
>
> Thanks gary
>
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups
"Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.
