On Saturday, January 13, 2018 at 2:06:35 PM UTC-5, gary wrote: > > is there a formula for calculating the radius to figure the distance i > need to change it after all corners are done? > Technically, there is an automated way to calculate it all based on the four height measurements, but I've never had as good of results with trying to do it that way. Once you got the corners set to be all the same you are 80% done anyway. Just changing it bit by bit seems to work the best.
> > I have the 3 corners set so there is slight drag on paper, now the center > is 0.5 above 0.0. > > Thanks gary > > On Saturday, January 6, 2018 at 8:42:16 PM UTC-5, gary wrote: > >> I just connected a BBB and Cramps board to my delta printer, but i have >> been having homing problem >> I have optic switches installed if i go into the hal configuration when >> machinekit it booted, and then to the show window with xmax ymax and zmax >> displayed then when axis's are off the switches there red, and when i >> trigger the switches they turn yellow >> So i assume the switches are working and being read by the software. >> >> But when i do home all the motors they move up to the switches in the >> correct direction but never stop just keeps running into the optic >> end stops and i have to power down.. >> >> any suggestions? >> >> Thanks gary >> > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
