I assume no one is using m104 or m109, and don't have any suggestions.. if i do a halcmd sets e0.temp.set 150 it will set the temp and it will rise up to 150 and hold within a degree or so.. so i know the hot end is working..
in a very old version of machinekit i did a m104 and used the #!/bin/sh halcmd sets e0.temp.set #P exit 0 and it worked but now it seems if you don't have the o<104> you get the error o word missing and when i use the command in a sub with o<104> i get the error unknown a Any thoughts. On Saturday, January 6, 2018 at 8:42:16 PM UTC-5, gary wrote: > I just connected a BBB and Cramps board to my delta printer, but i have > been having homing problem > I have optic switches installed if i go into the hal configuration when > machinekit it booted, and then to the show window with xmax ymax and zmax > displayed then when axis's are off the switches there red, and when i > trigger the switches they turn yellow > So i assume the switches are working and being read by the software. > > But when i do home all the motors they move up to the switches in the > correct direction but never stop just keeps running into the optic > end stops and i have to power down.. > > any suggestions? > > Thanks gary > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
