Where can you get them?
Gregg
-----Original Message-----
From: CP <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
Date: Monday, 27 March 2000 6:49
Subject: RE: X members 1600
>nar there big blocks of alloy shaped to fit in between the strut and the
>ball joint
>
>-----Original Message-----
>From: [EMAIL PROTECTED]
>[mailto:[EMAIL PROTECTED]]On Behalf Of Gregg Sheridan
>Sent: Monday, March 27, 2000 6:25 AM
>To: [EMAIL PROTECTED]
>Subject: Re: X members 1600
>
>
>Are those spacers just thick washers or what? Do you make em yourself or
buy
>them?
>
>Gregg
>-----Original Message-----
>From: Derek Franklin <[EMAIL PROTECTED]>
>To: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
>Date: Monday, 27 March 2000 10:43
>Subject: Re: X members 1600
>
>
>>X-members are, as has been said, different from year to year.
>>
>>When I chased this up 18 months ago I went to a wrecker with a dozen or
>>more 1600s, measured every one of those friggin' x-members and found about
>>2 that were the same. I used an accurate technique to measure the
>>difference in height between the flange on the x-member where it bolts to
>>the body and the centre of the control arm pickup point, and found that
>>inconsistency was the rule. If you measure from the lower edge of the
>>x-member up to the pickup point you won't do any good in my opinion, too
>>much part-swapping ( and maybe big tolerances from factory ) to go by the
>>year.
>>
>>I grabbed the best of them, gained about 19-20mm compared to my original -
>>made a noticeable difference but not immense. I think the 'bumpsteer
>>spacers' between the outboard end of the control arm and the bottom of the
>>strut would be necessary to correct the problem properly, or even better
>>have the steering arms re-bent to correct the misalignment that causes
>>bumpsteer.
>>
>>DF
>>
>>
>>At 20:32 25/03/00 +1100, you wrote:
>>> Listers Are all 1600 X members the same? I ask this because I went
>>>to put my motor in today and the sump was hitting the X member.1968
>model.
>>> Maybe, just a thought, are all L16 sumps the same?Or could it be
>engine
>>>mounts? ( I did check tne manual and they look the same) Thanks Dave
>>
>>
>>
>
>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
---------------------------------------------------------------------
