Howzit
L18 freshly rebuilt is still running too hot for my liking. Ive checked the
thermostat (180 F) works fine and its water is definately flowing good the
radiator was recently rebuilt so it shouldn't be blocked. Im wandering if
the cam wasn't dialed in correctly or the timing was off if it would cause
this to over heat.
I am running the cam sprocket on # 2 but there was still a decent gap in the
spring tensioner and both the head and block have been shaved should this
have been on #3? i was a little unsure if the cam was at TDC. The dowel was
slightly to the left of vertical but i assumed it was ok here probably
should have been dead straight up.
What do you reckon?
Craig
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.datascribe.com.au/ozdatonline/index.htm
http://www.datascribe.com.au/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
