Thanks Bob, I would certainly like to see how you design this sort of thing.
Some explanatory notes on what the bits do would be good. regards Terry -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Bob Sent: Monday, 18 February 2002 6:24 PM To: [EMAIL PROTECTED] Subject: Re[8]: 200B fuel tank in 1600 fuel gauge calibration? Hello Chris, I have a regulator working now, total cost was about $3, its adjustable down to about 1.2v. I havent tested its current capabilities yet, but the data sheets on the regulator specify that it can supply 1.5A, so for a fuel gauge it should be heaps. If you were going to use it for anything much higher, I would start thinking about fitting a small heatsink to the regulator itself. Anyone interested in the diagrams I can send them to you, just send me your address. Chris, where abouts do you live? I am in Wollongong, so if you are in the area I can just send it to you or something, otherwise you could make your own for cheap or I can post it to you. Monday, February 18, 2002, 10:50:15 AM, you wrote: --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
