Hello Mark, I have only tackled that problem once, but I got one of those easy outs from autopro for about $4 and that got it out like a charm - the only problem I had is they have a really small drive on the back, looks like 1/16th or something, but vice grips make do. Apparently giving it a bit of a whack in the centre with a centre punch or something like that can help loosen them up (not enough to damage it thought).
Wednesday, June 05, 2002, 3:33:19 PM, you wrote: MF> Hi listers, MF> I have struck a small problem with my L20B. One of the holes in the block where the engine mounts bolt into has half a screw in there but the head has snapped off. It is too far in to grip, so i MF> was going to try to drill a hole in the screw and reverse thread it to get it out but i thought i'd ask if anyone had any good tricks for getting them out first. Any suggestions? MF> Thanks, MF> Mark. MF> _____________________________________________________________ MF> Get Your free Ozdat Email Account --->> http://www.ozdat.com MF> _____________________________________________________________ MF> Promote your group and strengthen ties to your members with [EMAIL PROTECTED] by Everyone.net http://www.everyone.net/?btn=tag -- Best regards, Bob mailto:[EMAIL PROTECTED] --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
