Have you checked the throttle cable to see if it's binding or it it may be dirty enough inside the conduit that it's movement is affected? ____________________________________
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Frank Sent: Thursday, May 01, 2008 2:09 PM To: [email protected] Subject: Re: Link mk1 - High idle problem TPS signal is ok. The * is there at idle and goes away as soon as I touch the pedal. It comes back after blipping the throttle, so TPS should be ok. I checked all lines and found no vacuum leaks. Cleaned both grounds on the RH side of the engine. Didn't do the one near the dipstick as it was a tad too hot there Will do so next week (leaving for a Disney weekend in the morning). It never goes in row 2 when this is happening. Blip the throttle and 2 out of 3 times, it goes to 2K rpm and just hangs in zone 115. When I blip the throttle and it does come down, it drops to 1500 rpm, goes back up to 2K, hangs there for a second or 2 and then falls back to 1500 and than slowly to normal idle. Other thing I noticed is that just touching the accelerator makes it go up to 2K all by itself. Sometimes it comes back down, sometimes it doesn't ... Fuel zones at idle are set according to the manual and have worked fine since I bought the ECU, about 6-7 years ago or so, Bill? BTW Bill, are there still chips available for this ECU? Frank **************Wondering what's for Dinner Tonight? Get new twists on family favorites at AOL Food. (http://food.aol.com/dinner-tonight?NCID=aolfod00030000000001)
<<inline: Emoticon1.gif>>
_______________________________________________ Miatapower mailing list [email protected] http://list.miatapower.net/cgi-bin/mailman/listinfo/miatapower
