I don't know much about dimming these but some of the earliest dimming 
solutions for Nixies that I've seen actually used diac/triac/thyristors 
with unsmoothed half- or fullwave rectified mains voltage, and also some 
transistorized solutions.

Maybe something similar could be used here, they either controlled the 
anode voltage before the anode resistor or affected the voltage after the 
anode resistor, right at the anode of the Nixie, by lowering it to get a 
dimming effect. Much like a triac/diad dimmer does affect the mains voltage.

/Martin

On Thursday, 27 August 2020 19:56:25 UTC+2, Paul Andrews wrote:
>
> If we assume that these panels are designed to run off full-wave rectified 
> 220V, perhaps here in the U.S. a Villard voltage doubler 
> <https://www.intechopen.com/books/advanced-electronic-circuits-principles-architectures-and-applications-on-emerging-technologies/high-voltage-energy-harvesters>
>  
> would work? OTH, if you want to be able to dim/fade these panels, you would 
> probably want a DC voltage. It seems like there would be no point PWMing at 
> a few kHz on top of a 50/60Hz wave.
>

-- 
You received this message because you are subscribed to the Google Groups 
"neonixie-l" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
to [email protected].
To view this discussion on the web, visit 
https://groups.google.com/d/msgid/neonixie-l/c3ea3fa6-43e9-4c11-9c7a-b23ddeb97752o%40googlegroups.com.

Reply via email to