Don-- Thanks for the tips. I don't even really get what the point of the pre-echo mute is, and I have literally never used it. I should definitely do that.
== doesn't hurt to reflow those joints because I found a few cold joints when I recapped my Series II a few years ago. Also check the female Molex connectors where they're soldered to the board. I've seen weak joints here as well. == I presume you mean male connectors here, at least for the master module. Or do you mean the the female connectors on the PCB below channel cards? Matt On Fri, Jun 26, 2009 at 12:08 AM, Donald Put<[email protected]> wrote: > I forgot to mention that the spring connectors in the female Molex > connectors can appear to be just fine, but if you check them with something > that will fit and is roughly the same size as the mating pin, you might find > a bad one. I use a dental pick and have found them this way easily. It's > weird because they look like their neighbors, but once you push something in > you'll find there is no tension. > > Cheers, > -- > Don > > ------ View the list online at: http://www.mail-archive.com/[email protected] You can unsubscribe at anytime by sending an email to mailto:[email protected] with "unsubscribe neotek" in the message body. If you have any difficulties, or questions --please send an email to mailto:[email protected]. The Neotek list is lovingly hosted by Catapult Web. Remember that any message or reply sent to the list will be automatically forwarded to all subscribers. Vive Le Neotek! Thanks.
