Man, I have no idea why the heat would be affecting it. That said both cyls aren't that hard to rebuild. Basically you order the rubber bits, tear it apart, clean it really well, take care putting it back together, then go back through the PiTA process of bleeding it again. I took pics of my rebuild in the links below.
http://munz.kicks-ass.net/nighthawk/?p=172 http://munz.kicks-ass.net/nighthawk/?p=187 http://munz.kicks-ass.net/nighthawk/?p=196 -Kyle On Tue, Aug 2, 2011 at 5:25 PM, Mike21222 <[email protected]> wrote: > Ok, I've bled the clutch twice, the problem still existed, so I had it > done at the shop. > It is still doing the same thing, the shop recommends rebuilding the > master cylinder, but the trouble only occurs when the bike gets hot. > Then I have to pump the clutch to get it to disengage. If it's only > when its hot, how could that spell master cylinder, seems the heat is > localized to the slave cylinder area and the clutch mechanism itself. > Perhaps I should replace the slave sylinder. Or have it rebuilt. Or > maybe I should have both rebuilt? Any comments? Mike > > On Jul 28, 7:51 pm, Mike21222 <[email protected]> wrote: > > I have a recently purchased 1984 CB650SC, it's been running fine for a > > few weeks, got the oil changed a few days ago, and new tires. and > > since then I have noticed the clutch is starting to act up. It works > > fine when the engine is cold, but once the engine gets heated up, it's > > tough to disengage the clutch. I have checked the clutch master > > cylinder, it needed fluid, I added a little DOT 3, just as the book > > prescribes. It ran fine on the way home, once I got home the clutch > > again was acting like it did not want to disengage. Anyone know what > > might be going on here? Could it be they used the wrong viscosity of > > oil? Could overheating cause this? How about the slave cylinder? There > > are no leaks anywhere. I think the bike sat for about a year before I > > bough it. I also thjink its been quite a while since someone checked > > the master cylinder because the screws were seized up and I had to tap > > them both out. I replaced them with allen screws from a fastener > > store. Any helpful suggestions out there would be appreciated. > > Mike > > -- > You received this message because you are subscribed to the Google Groups > "Nighthawk Motorcycle Lovers!" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]. > For more options, visit this group at > http://groups.google.com/group/nighthawk_lovers?hl=en. > > -- You received this message because you are subscribed to the Google Groups "Nighthawk Motorcycle Lovers!" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/nighthawk_lovers?hl=en.
