On 09:49 AM 3/23/01 -0500, Jackson, Ken said:
>Is there anyway to display the workspace below the absolute origin. I can't
>get the display to scroll below this origin yet when I produce the gerber
>files and load them into CAMtastic, there is some text and copper that shows
>up 3 inches from the bottom of the board. I can remove this in CAMtastic
>but I would prefer to have a clean database.
FAQ fodder...
Edit->Select->Outside--->then select a window defined by the boundaries of
the schematic (the part you WANT to save)
Now Edit->deleTe
done...
regards,
aj
2.2 S E C O N D D R O P T O W E R
Andrew J Jenkins Electrical Engineer
National Center for Microgravity Research
NASA-Glenn Research Center MS 45-1
21000 Brookpark Rd, Cleveland OH 44135
(216) 433-5001 fax:433-3793
[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To join or leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *