I have two different testpoint components in my library, one for topside,
one for bottom. This way you can just select them by pattern and edit
the mask expansion.

Reed

At 12:29 PM 7/27/01 -0700, you wrote:
>Reed,
>   Your solution would work if all the test points are on one side.
>I have test points on both sides due to the high density of the product.
>   I am using vias for test points in some locations, so if I give them a
>negative expansion
>then I will be covering my testpoints with mask.
>   Making parts for each testpoint may be my only way.  With several hundred
>points it is
>more than a minor chore, but it would give me consistent results.  But even
>through hole parts don't let us manipulate the top and bottom masks
>separately.
>   We really need Protel to give us access to the soldermask pads on the top
>and bottom.
>Carl
>
>
>-----Original Message-----
>From: Reed Woltering [mailto:[EMAIL PROTECTED]]
>Sent: Friday, July 27, 2001 11:34 AM
>To: Protel EDA Forum
>Subject: Re: [PEDA] Test point tenting on side opposite TP
>
>
>The way I do this is to simply plot the soldermask for the side with the
>testpoints
>normally, and then select the testpoints, and edit the soldermask expansion
>for
>them to be negative, (ex: 30 mil TP gets -15mil expansion) and plot the
>opposite
>side to bury them in the mask.
>
>Reed Woltering
>Cad Manager
>Ariel Corporation
>
>At 09:35 AM 7/27/01 -0700, you wrote:
> >Hello,
> >    Has anyone figured out a work around so test points will only be
>exposed
> >on
> >the tested side and tented on the untested side (like under fine pitch SMT
> >components)?
> >    Editing the Gerber's is the only way I know to do this now.  :(
> >I would prefer something that be reproducible after revisions are made.
> >    Any news about a new version coming?
> >
> >Sincerely,
> >Carl Schattke, C.I.D.
> >Intel Corporation,  ACT
> >Sr. Hardware Engineer ( PCB Design)
> >122 Saratoga Ave. Suite 100
> >Santa Clara, CA 95052
> >Office 408-556-3122
> >Fax 408-261-5869
> >24 Hr. Ph. 888-204-3704
> >Email:  [EMAIL PROTECTED]
> >
> >

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to