carl,

have you clicked "top" or "bottom" test point in the pad/properties dialog
box? (double click on pad in component editor) i've not had any problems in
using that for a single-sided tp and not a th via.

hope this helps.

Joel L. Hammer
PCB Layout/Cad Specialist
E2 Enterprises Inc.
636.949.9101 Ext. 26
www.e2enterprises.com


> -----Original Message-----
> From: Schattke, Carl [mailto:[EMAIL PROTECTED]]
> Sent: Friday, July 27, 2001 11:36 AM
> To: Protel EDA Forum
> Subject: [PEDA] Test point tenting on side opposite TP
>
>
> Hello,
>    Has anyone figured out a work around so test points will
> only be exposed
> on
> the tested side and tented on the untested side (like under
> fine pitch SMT
> components)?
>    Editing the Gerber's is the only way I know to do this now.  :(
> I would prefer something that be reproducible after revisions
> are made.
>    Any news about a new version coming?
>
> Sincerely,
> Carl Schattke, C.I.D.
> Intel Corporation,  ACT
> Sr. Hardware Engineer ( PCB Design)
> 122 Saratoga Ave. Suite 100
> Santa Clara, CA 95052
> Office 408-556-3122
> Fax 408-261-5869
> 24 Hr. Ph. 888-204-3704
> Email:  [EMAIL PROTECTED]
>
>
>

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*                      - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to