Ken Pelic wrote:
> Dear Forum members,
>
> I submitted a design for fabrication that was put on hold for sub-5mil
> copper spacing, a conflict with our fab drawing notes. So far, I have
> located one case where different nets are 4.2 mils apart in the gerbers
> (using CAMtastic) yet Protel's DRC failed to flag this violation with the
> Clearance Constraint design rule set to 5 mils, different nets, board scope.
> I tried to manually measure the suspect spacing in Protel and found that
> with the snap grid set to the minimum of 1 mil, the Measure Primitives
> process still returns a value of 5 mils. I have tried different grid
> settings but cannot get a value of less than 5 mils...am I missing something
> here?
Don't use measure primitives, use Report Measure Distance. You may have
to set the snap grid to a small value, like .01 mil while you are doing the
measuring.
Jon
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *