At 05:14 PM 9/4/01 -0500, Jon Elson wrote:
>Don't use measure primitives, use Report Measure Distance. You may have
>to set the snap grid to a small value, like .01 mil while you are doing the
>measuring.
Reports/Measure Distance is not particularly good at accurately measuring
the distance between two primitives because one must visually attempt to
locate the edges of the primitives. If it falls on the snap grid, fine, but
otherwise Reports/Measure Primitives directly measures the gap between any
two primitives. It seems to be quite accurate.
Yes, if you are going to use Reports/Measure Distance, you may need to be
on a fine grid.
Abd ul-Rahman Lomax
LOMAX DESIGN ASSOCIATES
PCB design, consulting, and training
Protel EDA license resales
Easthampton, Massachusetts, USA
(413) 282-0013, efax (419) 730-4777
[EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *