We re-generated using 2.4 format and our gerbers now match our Protel PCB.
Thanks to all for your feedback, especially to Rob and Brad V!
Ken Pelic
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, September 05, 2001 8:12 AM
To: Protel EDA Forum
Subject: Re: [PEDA] Gerber clearance violations not found by Protel DRC
I have had this very problem when I had metric and inch mixed and the
gerbers were done in 2.3 format, I then changed to 2.4 or 2.5 and the same
file produced usaeble gerbers. So now whenever I have something with
primitives smaller than 10 and 10 I use 2.4 or 2.5 format. Roundup error
will kill you when your at clearances of 5 mils.
Rob
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
