At 11:38 AM 9/29/01 -0400, Bob Wolfe wrote:
>Just have a
>little reservation about converting any free trace to a net it was attached
>to, so I ran DRC's before
>running this function.

After running the update function, reloading the net list (through the 
Synchronizer, not the direct Netlist Load) should resolve any possible 
doubts. It does not remove the net assignments to component track, as I 
recall. The only problem is that if you used free pads for mounting holes, 
and you had a short to one of these pads, it could come to have the net to 
which it was shorted, and could easily overlook this. This is an argument 
for using mounting pad footprints; that way, their connection state is 
specified in the schematic.

[EMAIL PROTECTED]
Abdulrahman Lomax
Easthampton, Massachusetts USA

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to