so in essence what you are saying is too avoid partial planes?
Dennis Saputelli
Michael Reagan wrote:
>
> >
> Brad wrote:
> > understand what your fab shops have told you. Both are layers with mostly
> > copper rather than mostly laminate, should be absolutely no difference
> > between the two if you designed it to be identical.
> >
>
> Brad,
>
> The key is you said "mostly". It is my understanding that polygons on
> internal layers prevent the epoxies,glues to squish out uniformly when the
> laminates are pressed together, creating air pockets and voids therefore
> causing reduced reliability. Don't get me wrong, I used to used them also
> until I had some designs rejected by some board houses. I have several fab
> manuals that allow warn against using them.
>
> Mike Reagan
> EDSI
> Frederick MD
--
___________________________________________________________________________
www.integratedcontrolsinc.com Integrated Controls, Inc.
tel: 415-647-0480 2851 21st Street
fax: 415-647-3003 San Francisco, CA 94110
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
