Have you tried running a blank board (no solder, no components) through the solder/reflow heating cycle? And possibly a board with solder, but no components?
>> > Hi, >> > >> > We have a board warping problem and are looking for a PCB expert to help >> > resolve it. >> > (Preferably located in the UK, but not important) >> > >> > When I say expert, I mean *EXPERT*. The problem is quite complex and >>already >> > has baffled two manufacturers. >> > >> > We will pay the going rate for any consultation. >> > >> > Regards, >> > >> > Jason Morgan >> > > >Mark Witherite C.I.D. >Assistant Research Engineer >Astronomy & Astrophysics >Penn State University >2565 Park Center Blvd >Suite 200 >State College, PA. 16801 >email [EMAIL PROTECTED] >telephone 814 865 9839 >fax 814 865 9100 > > Cheesecote Mountain CAMAC, 24 Halley Drive; Pomona, NY 10970 voice: 845 364 0211, fax: 845 362 6947, www.cmcamac.com * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
