P99SE/SP6 shows the same behaviour but there you can ignore the error messages and do the simulation run with positive values even if Protel calls for negative ones . Do the simulation runs ok in DXP if you ignore the messages ? Did you already reported the behaviour to Altium ?
Rolf Molitor Ing.Buero i2e Remscheid / Germany -----Urspr�ngliche Nachricht----- Von: "Tim Hutcheson" <[EMAIL PROTECTED]> An: "peda" <[EMAIL PROTECTED]> Gesendet: Donnerstag, 8. August 2002 18:42 Betreff: [PEDA] DXP: Unable to set secondary step Value in Parameter Sweep > I just tried to run a simulation that included parameter sweep. When I try > to set a positive "Secondary Step Value" it says "step must be less than > zero". If I then try to set a negative step, it says it must be positive!! > > regards, > > Tim Hutcheson > Research Associate > Institute for Human and Machine Cognition > University of West Florida > 40 S. Alcaniz St. > Pensacola, FL 32501 > USA > 805-202-4461 > > > ************************************************************************ > * Tracking #: E9AEDF1F784B924CBDA581810BF9A19FB415138E > * > ************************************************************************ * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
