There may be some that are able to run the autorouter, I'm not amongst them, perhaps I didn't have the necessary patience.
Panelizing is done with copy and paste special. The paste special has some options. Give them a try. Rene Katinka Mills wrote: > > Hi all, > > I am just starting to have problems with P99SE, I have a design, it is a > simple 2 layer board, but it is having problems : > > #1 Auto Routing crashes protel on this design. (Access violation) > > #2 Routing one net at a time, causes the entire board to be routed and > crashes protel. (Acess violation) Not sure why it does the whole board when > all I asked it to do was one board. > > Also does anyone know how to panalise in P99SE (not a gerber as the fab shop > wants it in P99SE format, but I have to panalise the 2 designs) I tried to > make an outine of the panel and then cut and paste the PCB's in the panel, > but all my component ID's change eg R4 may be come R4_3_1 etc. ************************************************************************ * Tracking #: 23E430AF35440444954F88124D77F64E15BFBF73 * ************************************************************************ * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
