Well ADEEL, I am afraid that to actually have the system (99SE, don't know about DXP) match these leghts it will not do it, I was told any auto-router function, and this is one will not ahere to these rules. I tried it a few times where there was plenty of room to match the lengths of a delay loop and they were not even close so eneded up having to manually route these. I would also love to hear if there was a way in 99SE to get the system to match these lengths. Bob Wolfe ----- Original Message ----- From: "Adeel Malik" <[EMAIL PROTECTED]> To: "Protel EDA Forum" <[EMAIL PROTECTED]> Sent: Tuesday, August 13, 2002 9:36 AM Subject: [PEDA] Matched Lenghth Constraint
> Hi All, > I want to apply a matched-length constraint to the signals > connected to the bus. In the Protel Design Rule dialog, there are mainly 2 > parameters to specify, one is Tolerance (whose purpose is obvious) and the > other is Connection style. In connection style there are three options 1) 90 > degree 2) 45 degree and 3) Rounded. Alongwith them there are also options of > Amplitude and Gap.I couldn't understand these options so Can someone tell me > how these options are utilized effectively while routing a bus running at > 66MHz. > > Regards, > ADEEL MALIK > > > > ************************************************************************ > * Tracking #: 0E65D282D6969F409D601E4E0E422F8499FF2F09 > * > ************************************************************************ > > * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
