Hi Mr. Malik,

1 . Connection at 90 degree means the trace will place at at 90 degree on
bending like

                                    _______________
                                   !
                                   !
    ---------------------!

    2  45 degree mean on bends trace will be 45 degree
    3   Rounded mean on bends the trace will be rounded.

And 66 MHz is not so high so you may use any one you like.

Narinder
Solectron Invotronics



----- Original Message -----
From: "Adeel Malik" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Tuesday, August 13, 2002 9:36 AM
Subject: [PEDA] Matched Lenghth Constraint


> Hi All,
>          I want to apply a matched-length constraint to the signals
> connected to the bus. In the Protel Design Rule dialog, there are mainly 2
> parameters to specify, one is Tolerance (whose purpose is obvious) and the
> other is Connection style. In connection style there are three options 1)
90
> degree 2) 45 degree and 3) Rounded. Alongwith them there are also options
of
> Amplitude and Gap.I couldn't understand these options so Can someone tell
me
> how these options are utilized effectively while routing a bus running at
> 66MHz.
>
> Regards,
> ADEEL MALIK
>
>
>
> ************************************************************************
> * Tracking #: 0E65D282D6969F409D601E4E0E422F8499FF2F09
> *
> ************************************************************************
>

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/proteledaforum@techservinc.com
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to