No, doesn't do it Abd ul-Rahman.
   It will undoubtedly work just as it does now, it will set the correct scope for the 
sheet entry port connections but at the expense of turning off all other scopes. Where 
is that flexibility that you mentioned in earlier posts? There is no flexibility, just 
three hard coded options, that is not flexibility.
 
Sincerely,
Brad Velander

        -----Original Message----- 
        From: Abd ul-Rahman Lomax [mailto:[EMAIL PROTECTED] 
        Sent: Sat 26/07/2003 3:57 PM 
        To: Protel EDA Forum 
        Cc: 
        Subject: Re: [PEDA] P99SE Sheet Symbol & Port connectivity across sheets.
        
        

        At 09:59 PM 7/25/2003, Craig Scribner wrote:
        >Here's our current documentation for this. Please let me know if it's
        >unclear on any of the points that have been discussed.
        >
        >http://www.protel.com/resources/learningguides/articles/
        >connectivityandmultisheetdesign.pdf
        
         This does address Mr. Velander's
        comment about how he wants a Sheet Entry to do something, not just sit
        there useless, if he has placed it. 
        

見-jgkץy֟!wdzbXm
-ylz(kץǫ^jiB{ZrazXfjhvhkj+M!I"wah醺'^)ޱzm
-ylz(kץǫ髺W٥0+Irkzhاm
&j)Zb(kץy֟!w

Reply via email to