Gary- Protel does not provide that function in their EDA software but you can do it at the Gerber level using their CAM software. Just load your Gerber files into Camtastic and go to the 'Tools/Trim Silkscreen...' command.

IMO though, its a waste of your time because most fabricators do this as a standard procedure. Some fabricators take shortcuts though, so if you do want them to do it be sure to put such a note in your fabrication drawing.

Mark


At 12:43 PM 8/16/2003, you wrote:
Is there an automatic way to remove or prevent overlay lines from being placed on pads?

Thank you,
Gary Allbee
Alta Industrial Automation Ltd




* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[EMAIL PROTECTED] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *

Reply via email to