Hi clarence,
I just went through the FW 800 conversion to FW 400 with my Mbox pro 2 and let me tell you the Lacie drive did not work with that combo!!! I ended up getting a 800 to 400 fw pcie card for my Mac pro quad core and then PT saw the Mbox 2 pro finally. If I had to do it over I would have went with a FW 800 to FW 400 conversion cable! No telling if that would have worked either! LOL Now that I have installed my PT HD3 which by the way is just purring along, the pceie 800 to 400 fw card is sitting here in the box!! Any body need a conversion card its on sale!
 GROWLLLLLLL.
It may work for you but no guarantee    .
The $29 800 to 400 cable would probably be your most cost effective solution if you only have a 800 port.
talk soon

Chuck Reichel
954-742-0019
www.SoundPictureRecording.com


On Jul 10, 2010, at 5:45 PM, clarence griffin wrote:

oh yeah, and it only has 1 fw 800 port, its the 13 inch model.

GF


On Jul 10, 2010, at 1:58 PM, Slau Halatyn wrote:

I don't recall whether you're using a laptop or Mac Pro but, whatever the case is, if there's only one FireWire port available on the laptop, you absolutely need a chassis with at least 2 FireWire ports and hang the control surface off the drive. With FireWire stuff and Pro Tools, the interface is always last in the chain. Otherwise, yeah, if it's a MacBook Pro with 400 and 800 ports, it's possible to just keep the drive and interface on separate busses. Whatever configuration you're using, it should be way more than powerful enough to handle a ton of tracks.

Years ago, I did a remote session with an iBook which was only a 600 MHz processor and recorded 16 tracks live without any hiccups at all.

Slau

On Jul 10, 2010, at 12:03 PM, clarence griffin wrote:

ah! thanks. this sounds good. I didn't even think of that. so I need to get a caddy with 2 fw ports on it, then I can connect that to the mac, and the project mix to the drive. Is this correct? I just want to make sure I am understanding you correctly. I think that's right.

GF


On Jul 10, 2010, at 10:19 AM, Slau Halatyn wrote:

OK, yeah, I see what other people have since commented and, certainly, stay away from USB and I woldn't at all recommend recording to your internal drive. Yes, it will work and it'll work for a while but you're asking for trouble. The way the interface connects is by being the last item in the FireWire chain. Get a drive with two FireWire ports and connect computer to drive and drive to interface. The smaller compact bus-powered drives have fewer options in terms of multiple You'll want to go with something a bit more substantial. If the computer has a FW 800 port, you can record to that bus and use the 400 bus just for the interface.

HTH,

Slau
ports.
On Jul 9, 2010, at 8:19 PM, clarence griffin wrote:

I disabled the drive I was recording to from the spot light settings. Maybe I can't use an external drive? Its USB 2.0. I would think that's fast enough. Maybe I need to record to my hard drive? If so. I have a lot of clearing out of stuff to do.
Any suggestions??

GF







Chuck Reichel
954-742-0019
www.SoundPictureRecording.com



Reply via email to