When you fitted the alloy inlet manifold which injector wiring loom did
you fit, the one from the alloy manifold or the one from the Escort
plastic manifold ?
As somebody else found recently there are slight wiring differences
between the 2 involving the cam sensor and air temperature sensors.
Jim
On 07/06/2010 10:42, geoff ward wrote:
Hi Jim,
Not sure about that, don't know what you mean by throttle pot,
hopefully Steve will respond.
At the moment the car is in Aylesbury but has been at Steve's near Woking.
Geoff.
On 7 June 2010 10:28, Jim Hearne <[email protected]
<mailto:[email protected]>> wrote:
Did you do any electrical tests on the throttle pot.
Where is the car ?
Jim
On 07/06/2010 10:19, geoff ward wrote:
Hi all and thanks again for all the helpful suggestions.
Steve and I have checked and double checked through all that has
been suggested, every thing seems to work as it should
individually. The idle speed control vale has been thoroughly
cleaned again and checked to see that it works, then refitted
with a new gasket and that it receives input, electronically,
from its plug. Steve has checked all the connections with his
testing equipment, it's all beyond me!, and it all works. We have
reset the ECU yet again, despite spending all day Saturday trying
to get it to run properly, it still has the same problem.
Thank you Steve for all the time and effort you have put in so
far to try and fix it.
So if any of you have any further suggestions, we would be
pleased to hear them, as Carole and I are getting worried now,
with only one weekend to go before we head to Scotland.
Yours hopefully Geoff.
On 1 June 2010 22:59, geoff ward <[email protected]
<mailto:[email protected]>> wrote:
Thank you to all for your help and advice, I will do a bit
more checking and cleaning of contacts etc tomorrow. The
strangest thing,as Steve mentioned in his original post, is
that the engine idles perfectly
at around 900 - 1000 rpm (according to the XR2 rev counter)
when you first start it up. I have followed the method for
resetting the ECU 4 times know and it has had good idle speed
every time for the first stage of the reset, ie allow to idle
for 10 -15 mins (DO NOT TOUCH THE THROTTLE) it only goes all
wrong after that! As soon as you start to drive it, that's
when it wont idle properly anymore.
Carole say thank you all.
Regards, Geoff.
On 1 June 2010 12:29, Steve Kodz <[email protected]
<mailto:[email protected]>> wrote:
We're getting a very bad idle with the Zetec in Carole's
2+2. With the idle
speed control valve connected from cold it will idle
nicely at around
1000rpm, if just left to idle and warm through. However
if you rev, or
drive that car the best idle to can get is between
2-3,000 rpm, which isn't
great :( The car also drives badly, having hesitation
and then you fight
the engine on the over run.
It is a lot better with the ISCV disconnected, but still
not great. The
idle is still a bit high, being around 1,200 rpm and it
still doesn't drive
that great.
We've tried resetting the ECU to re-program it and
Geoff's cleaned all the
electrical contact and the ISCV. Any ideas what else
needs to be done to
get this ready before the HHII?
Regards,
Steve
--
www.h4-turbo.co.uk <http://www.h4-turbo.co.uk/>
www.quantumowners.co.uk <http://www.quantumowners.co.uk/>
www.quantumcars.co.uk <http://www.quantumcars.co.uk/>
www.quantumheritage.co.uk <http://www.quantumheritage.co.uk/>
--
You received this message because you are subscribed to
the Google Groups "Quantum Owners Group" group.
To post to this group, send email to
[email protected]
<mailto:[email protected]>
To unsubscribe from this group, send email to
[email protected]
<mailto:[email protected]>
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is
provided on an "As Is" basis, without warranty or the
implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club
or in the preparation of the above information shall have
any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused
directly or indirectly by the instructions contained
within this or related message(s).
--
You received this message because you are subscribed to the
Google Groups "Quantum Owners Group" group.
To post to this group, send email to
[email protected]
<mailto:[email protected]>
To unsubscribe from this group, send email to
[email protected]
<mailto:[email protected]>
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on
an "As Is" basis, without warranty or the implication thereof.
Neither the Quantum Owners Club nor the individuals associated
with the Quantum Owners Club or in the preparation of the above
information shall have any liability to any person or entity with
respect to liability, loss, or damage caused or alleged to be
caused directly or indirectly by the instructions contained
within this or related message(s).
--
You received this message because you are subscribed to the Google
Groups "Quantum Owners Group" group.
To post to this group, send email to
[email protected] <mailto:[email protected]>
To unsubscribe from this group, send email to
[email protected]
<mailto:[email protected]>
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on
an "As Is" basis, without warranty or the implication thereof.
Neither the Quantum Owners Club nor the individuals associated
with the Quantum Owners Club or in the preparation of the above
information shall have any liability to any person or entity with
respect to liability, loss, or damage caused or alleged to be
caused directly or indirectly by the instructions contained within
this or related message(s).
--
You received this message because you are subscribed to the Google
Groups "Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an
"As Is" basis, without warranty or the implication thereof. Neither
the Quantum Owners Club nor the individuals associated with the
Quantum Owners Club or in the preparation of the above information
shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or
indirectly by the instructions contained within this or related
message(s).
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).