rowave Products Division has now achieved ISO 9001:2000
certification
> -Original Message-
> From: Dennis Saputelli [mailto:[EMAIL PROTECTED]]
> Sent: Friday, October 04, 2002 9:56 AM
> To: Protel EDA Forum
> Subject: Re: [PEDA] P99SE SP6 Problem with Update PCB (Solved for
m
> Subject: Re: [PEDA] P99SE SP6 Problem with Update PCB (Solved for the
> inte rim!)
>
>
> I wonder if there is a breakdown in the hierarchy of the
> system rather than
> the synch itself.
>
> Brad, does/did the hierarchy look OK?
> You can get a report on the hierar
could you please clarify:
when wishing to destroy the handles made by the synchronizer
do you save the PCB as ASCII or the SCH or both?
thanks
Dennis Saputelli
Ian Wilson wrote:
>
> On 04:33 PM 4/10/2002 +1200, [EMAIL PROTECTED] said:
>
> >Yeah, it seems to be pointing at a problem with the
On 04:18 PM 4/10/2002 +1000, Ian Wilson said:
> I would normally design my sch to have full net/port/sheet entry
> connections with all the correct input/output types and top level
> interconnections. I would then do a full ERC with the most restricted
> net scope and make sure all is OK. Bu
On 04:33 PM 4/10/2002 +1200, [EMAIL PROTECTED] said:
>Yeah, it seems to be pointing at a problem with the synchronizer when used
>in "nets and ports global" mode. I think Brad mentioned it worked ok if he
>went via the netlist method (while using separate sheets).
>
>As I said in an earlier post
Yeah, it seems to be pointing at a problem with the synchronizer when used
in "nets and ports global" mode. I think Brad mentioned it worked ok if he
went via the netlist method (while using separate sheets).
As I said in an earlier post using nets and ports global is the only time I
have exper
this is interesting
were you using (before big sheet) 'nets and ports global'
might be a clue
Dennis Saputelli
Brad Velander wrote:
>
> Guys,
> my problem with duplicate nets is solved for the interim but I will
> be searching for the causes later. I copied the separate schematics to
Guys,
my problem with duplicate nets is solved for the interim but I will
be searching for the causes later. I copied the separate schematics to one
large sheet and the problem vanished. No other changes were made.
When I have bit more time I will still try to find an issue in the