----- Original Message ----- From: "Ode Coyote" <[email protected]>
> Ivan > I use controlled current at .7 to .8 milliamps, voltage at 25.6 to start > ,dropping to 6 volts as conductivity increases. The higher current setting > tends to make for a higher risk of larger particles, especially if the > water is cool but it 'usually' works fine if the temperature is kept around > 80 to 100 degrees F. Temperature over 120 deg tends to yield larger > [yellow] particles especially afterwards when the CS cools. The TE is > initially quite faint but gets brighter with time in storage and PPM meter > readings drop accordingly. Ken I'm using .5mA current limit, 30V start, finishing at about 11V. Using an Ion Selective Electrode to measure concentration. Concentration increases slightly over 48 hrs no colour no Tyndal to speak of. > That voltage is not great enough to overcome resistance in very pure water > at first, so, current is lower than the control allows. Several different > things tend to happen under those conditions that seem to carry through to > the end as if a pattern is being set up...mostly deposit formations. > Thermal 'stirring' with a slow rate of production or mechanical stirring > with a higher current setting produces a clear CS of up to 22 PPM...with a > few exceptions, cause unknown. I've had 2 [out of 10] batches of 17+ PPM > /mechanically stirred in luke warm water and made at 2 milliamps turn pale > violet within a month under cool storage without ever being yellowish. > [fall/winter room temeratures] > Are you using controlled current? > Ken Was that pale violet with turbidity or clear? Tyndal? I made some CS violet and clear with an experimental machine. Stopped generating at 20ppm and within 24hrs the concentration had increased to 50+ppm, it had the most powerful lip-smacking taste of any CS I ever tried. I suspect the silver had lost more than one electron. Ivan. > At 02:02 AM 11/21/00 +1300, you wrote: > >Hi Bob, > > > >I have found that hot water leads to a stronger Tyndal beam and greater > >colour in CS of equivalent concentration. And unlike Ken (hi Ken) have > >found that using seeding leads to much larger particles. Must be doing > >something wrong! > > > >Ivan. > > > >----- Original Message ----- > >From: "Robert L. Berger" <[email protected]> > >To: "Silver-list" <[email protected]> > >Sent: Sunday, 19 November 2000 14:13 > >Subject: CS>development work > > > > > >> Hi Ya'all, > >> > >> Is there anyone on this list that has done any kind of study that > >> compares any given protocol to make CS when the water temperature is > >> varied??? > >> > >> I would appreciate any data or observations that you may have. It > >might > >> just be the change in T.E. with temperaure. > >> > >> I want to improve the HVAC ARC CO2 method to get faster "knowdown" of > >> pathogens when doing culture studies. > >> > >> "Ole Bob" > >> > > > > > > > >-- > >The silver-list is a moderated forum for discussion of colloidal silver. > > > >To join or quit silver-list or silver-digest send an e-mail message to: > >[email protected] -or- [email protected] > >with the word subscribe or unsubscribe in the SUBJECT line. > > > >To post, address your message to: [email protected] > >Silver-list archive: http://escribe.com/health/thesilverlist/index.html > >List maintainer: Mike Devour <[email protected]> > > > > >
