On Sat, Sep 12, 2009 at 9:05 PM, James Johnson <[email protected]>wrote:
> > > Ranga, > > I have confirmed that Xlite works fine with both incoming & outgoing calls. > Here are my ITSP settings from sipXBridge-1: > The FreeSwitch based Auto Attendant is quite picky about symmetrical statically mapped full cone NAT. It does its own NAT compensation. It will only send to a port from which it receives data (i.e. does its own NAT compensation). You can try setting up a DID alias for some phone other than the auto attendant. Then leave the "inbound calls destination" field blank in sipxbridge. This will route your inbound call directly to the phone for which you have set up that DID alias. I am afraid you are going to need to dig into this problem using wireshark and sipviewer if that does not work. Check to see if signaling is even getting to sipxbridge. If that is not happening you need to gather traces from the public side of the firewall to see if the ITSP is sending signaling there and where the signaling is being forwarded to ( or dropped ). Regards Ranga -- M. Ranganathan
_______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
