Who is the ITSP?
On Wed, Nov 4, 2009 at 12:01 PM, Burden, Mike <[email protected]> wrote: > The new ITSP is not assigning a username/password, and is simply > authenticating us by our source IP address. > > When I set up the Gateway for the new ITSP, I simply left the username and > password blank. > > > > Is that the correct thing to do? > > > > > > > > *From:* [email protected] [mailto: > [email protected]] *On Behalf Of *Burden, Mike > *Sent:* Wednesday, November 04, 2009 12:00 PM > > *To:* [email protected] > *Subject:* Re: [sipx-users] Multiple gateways? > > > > As a test, I removed the Gateway for the SIP Trunk to the first ITSP, > leaving only the Gateway to the new ITSP. > > > > I’m still getting a fast busy, so apparently I have a problem with the > Gateway configuration for the new ITSP. > > Could that prevent the sipXecs from placing an outbound call correctly, > even though there was another, working > > Gateway specified ahead of it in the Dial Plan? > > > > > > > > *From:* [email protected] [mailto: > [email protected]] *On Behalf Of *Burden, Mike > *Sent:* Wednesday, November 04, 2009 11:47 AM > *To:* [email protected] > *Subject:* [sipx-users] Multiple gateways? > > > > Good morning, > > > > > > OK, I’m brand new to both IP telephony and sipXecs, so if I’ve done > something dumb, go easy on me. :) > > > > > > I have sipXecs working correctly with a SIP trunk to our ITSP. This > Gateway uses the Internal SBC (sipXbridge-1) as the route. > > > > I want to add a SIP trunk to a second ITSP. I went to Devices -> Gateways > -> Add New Gateway -> SIP Trunk and filled in the information for the new > ITSP, and set up the Dial Plan so that the original Gateway was first, > followed by the Gateway to the new ITSP. The new Gateway also uses > shipXbridge-1 as the route. > > > > After restarting services, outbound calls do not work at all (fast busy.) > > > > I removed the Gateway for the new ITSP from the Dial Plan and restarted > services, but it still didn’t work (still fast busy.) > > > > I removed the new Gateway and restarted services again, and everything > worked again. > > > > > > Where am I going wrong? Shouldn’t the system use the Gateways in the > order I specified in the Dial Plan? > > > > > > > > Mike Burden > > Lynk Systems, Inc > > e-mail: [email protected] > > Phone: 616-532-4985 > > > > > > _______________________________________________ > sipx-users mailing list [email protected] > List Archive: http://list.sipfoundry.org/archive/sipx-users > Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users > sipXecs IP PBX -- http://www.sipfoundry.org/ > -- ====================== Tony Graziano, Manager Telephone: 434.984.8430 Fax: 434.984.8431 Email: [email protected] LAN/Telephony/Security and Control Systems Helpdesk: Telephone: 434.984.8426 Fax: 434.984.8427 Helpdesk Contract Customers: http://www.myitdepartment.net/gethelp/
_______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
