I know that 5080 is the default port for sipXbridge. To make sure my calls are coming on in 5080, do I need to request that from AT&T?
Andrew > -----Original Message----- > From: Picher, Michael [mailto:[email protected]] > Sent: Tuesday, February 16, 2010 12:47 PM > To: Andrew Cotter; [email protected] > Subject: RE: [sipx-users] Problem with transfers from external calls > > Make sure that Internet Calling check box is off and that > your calls are actually coming in on 5080 and not 5060. > > > -----Original Message----- > > From: [email protected] [mailto:sipx-users- > > [email protected]] On Behalf Of Andrew Cotter > > Sent: Tuesday, February 16, 2010 5:04 AM > > To: [email protected] > > Subject: [sipx-users] Problem with transfers from external calls > > > > Good morning, > > > > Almost there with our system, but it appears that I have > one issue to > > resolve. AT&T finally got around to putting in their IP > Flex product > > and it works well except for transfers. > > > > The problem shows up in two places which seem like the same issue. > > First, when an outside call comes in to the AA I try either dial by > > name or dialing the extension. Both end up recognizing the tones, > > announce that I will be transferred, and then dead air. > Phone to be > > transferred to never rings. > > Second is a DID call to a phone and that phone tries to > transfer the > > call to another phone. Internal transfers work and transfers work > when > > coming in from the copper lines using an AudioCodes MP-118 fxo > gateway. > > > > Lay of the land.... > > > > Sipx is set as 172.21.210.10 and is using 4.0.4 > > > > Cisco 7604 router has three ports, WAN, LAN, SIP. While > setting this > > up with AT&T it was my understanding that I should have an > internal IP > > on the SIP port. We had them set it as 172.21.210.9. > Seems to work > > except for this. > > > > We setup sipx to use an unmanaged gateway that points to > the public IP > > AT&T gave us to connect to. > > > > Attached is a merged trace file that I have been looking at in > > sipviewer. > > Just wish I knew what I was looking for in this. The two > lines that > > from a newbie perspective look like possible culprates are the "407 > > Proxy Authentication Required" and "408 Request timeout". > > > > Everything I have been reading points be back to REFER, but I am > stuck. > > Any pointers or thoughts? > > > > > > BTW - sipviewer seems like a great debug tool! > > > > > > Andrew > _______________________________________________ sipx-users mailing list [email protected] List Archive: http://list.sipfoundry.org/archive/sipx-users Unsubscribe: http://list.sipfoundry.org/mailman/listinfo/sipx-users sipXecs IP PBX -- http://www.sipfoundry.org/
