Hi Brian, thought about it too, however, when I delete the first two successfully handled files from the sequence and start the database search again with the next / third file of the list, the subsequent two files are also successfully sent through the pipeline. I repeated it a few more times now and to me it looks like as if XTandem database searches are currently only possible in tranches of two. Strange, isn´it?
Hannes 2010/2/24 Brian Pratt <[email protected]>: > You'll want to narrow it down to identify the problem - for example, what > happens when you omit that 3rd file? > > On Wed, Feb 24, 2010 at 2:04 AM, hcadrexler <[email protected]> > wrote: >> >> Hi there, >> >> I tried to perform an XTandem search following the XTandem 2009 >> tutorial using my own data (29 mzXML files). The Database search is >> performed for the first two files in the sequence without any problems >> but then stops and does not proceed any further with the third (and >> subsequent) files. I cannot figure out where the mistake was made. >> Does anybody know why this might happen? >> >> Kind regards, >> >> Hannes >> >> -- >> You received this message because you are subscribed to the Google Groups >> "spctools-discuss" group. >> To post to this group, send email to [email protected]. >> To unsubscribe from this group, send email to >> [email protected]. >> For more options, visit this group at >> http://groups.google.com/group/spctools-discuss?hl=en. >> > > -- > You received this message because you are subscribed to the Google Groups > "spctools-discuss" group. > To post to this group, send email to [email protected]. > To unsubscribe from this group, send email to > [email protected]. > For more options, visit this group at > http://groups.google.com/group/spctools-discuss?hl=en. > -- You received this message because you are subscribed to the Google Groups "spctools-discuss" group. To post to this group, send email to [email protected]. To unsubscribe from this group, send email to [email protected]. For more options, visit this group at http://groups.google.com/group/spctools-discuss?hl=en.
