> the second problem still remains and bus can not re-enter the road after the traffic volume increases You can change the junction type where the bus bay ends to "zipper" to ensure that the bus can merge.
> I see that emission outputs reported "zero" for some vehicles while they were on their way. https://github.com/eclipse/sumo/issues/2110 Am Sa., 30. Apr. 2022 um 22:38 Uhr schrieb ali mirzaei <[email protected] >: > I could insert the bus into its bay as you said and the emission outputs > were recorded continuously. But, the second problem still remains and bus > can not re-enter the road after the traffic volume increases. On the other > hand, in some time steps, I see that emission outputs reported "zero" for > some vehicles while they were on their way. > > > On Sat, Apr 30, 2022 at 4:10 PM Jakob Erdmann <[email protected]> > wrote: > >> startPos and pos must be in the range [0, 12] to stop on that edge. The >> values always count from the start of the stop edge. >> >> Am Sa., 30. Apr. 2022 um 00:45 Uhr schrieb ali mirzaei < >> [email protected]>: >> >>> I think I did so, didn't I? >>> My startPos = 112.19 and the pos = 124.49 >>> >>> On Sat, Apr 30, 2022 at 2:31 AM Jakob Erdmann <[email protected]> >>> wrote: >>> >>>> the lane for the bus bay is only 12m long. You'll have to set your stop >>>> position within that range. >>>> >>>> Am Fr., 29. Apr. 2022 um 22:34 Uhr schrieb ali mirzaei < >>>> [email protected]>: >>>> >>>>> I did what you said in my opinion but at the beginning of the >>>>> simulation I faced the error : stop for vehicle 'bus_1' on lane 'e2_0' has >>>>> an invalid position. Could you tell me what mistakes I have made? (I have >>>>> attached my files for possible information required) >>>>> >>>>> >>>>> On Fri, Apr 29, 2022 at 3:16 PM Jakob Erdmann <[email protected]> >>>>> wrote: >>>>> >>>>>> The extra lane should only be as long as the bus bay and you'd >>>>>> typically need to split the original edge into 3 parts to achieve this. >>>>>> >>>>>> Am Fr., 29. Apr. 2022 um 12:37 Uhr schrieb ali mirzaei < >>>>>> [email protected]>: >>>>>> >>>>>>> I added an extra lane and used it as a bus stop at the specified >>>>>>> coordinates but before getting there, the bus makes a lane change from >>>>>>> the >>>>>>> upstream (which is not desired) and after the end of the stop period, it >>>>>>> moves in the extra lane and no longer backs to its primary lane (which >>>>>>> is >>>>>>> not desired, too). >>>>>>> >>>>>>> On Fri, Apr 29, 2022 at 10:32 AM Jakob Erdmann < >>>>>>> [email protected]> wrote: >>>>>>> >>>>>>>> 1. if a vehicle stops with attribute parking="true", it no longer >>>>>>>> records emissions (up to the time where the stop ends and it tries to >>>>>>>> re-enter the network) >>>>>>>> 2. if a vehicle returns from the "parking" state, road traffic will >>>>>>>> generally not be are of it's wish to re-enter the road and thus not >>>>>>>> open a >>>>>>>> gap >>>>>>>> >>>>>>>> Both issues can be solved by modelling each bus bay with an extra >>>>>>>> lane and having the bus stay on that lane during it's stop. >>>>>>>> >>>>>>>> Am Fr., 29. Apr. 2022 um 00:15 Uhr schrieb ali mirzaei < >>>>>>>> [email protected]>: >>>>>>>> >>>>>>>>> Hi everyone, >>>>>>>>> Using the ~.setStop() method, my buses start performing station >>>>>>>>> operations where they were previously assigned. The emission class is >>>>>>>>> "HBEFA3/PC_G_EU4". >>>>>>>>> 1 - After observing some irregularities in the emission curves, I >>>>>>>>> evaluated the emission outputs and found that at the moment the >>>>>>>>> vehicle >>>>>>>>> arrived at the station, the whole emission attributes turned to zero >>>>>>>>> and >>>>>>>>> after that no data of the vehicle was recorded for the duration >>>>>>>>> length. >>>>>>>>> This process stops when the vehicle leaves the station and the >>>>>>>>> pollution >>>>>>>>> information is recorded again. Why does this happen? >>>>>>>>> 2 - When I add more vehicles to the road to simulate the rush hour >>>>>>>>> effect on the operation, the merging of the bus would not happen in >>>>>>>>> the >>>>>>>>> determined period. How can I fix it? >>>>>>>>> Best regards, >>>>>>>>> Ali >>>>>>>>> >>>>>>>>> _______________________________________________ >>>>>>>>> sumo-user mailing list >>>>>>>>> [email protected] >>>>>>>>> To unsubscribe from this list, visit >>>>>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>>>>> >>>>>>>> _______________________________________________ >>>>>>>> sumo-user mailing list >>>>>>>> [email protected] >>>>>>>> To unsubscribe from this list, visit >>>>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>>>> >>>>>>> _______________________________________________ >>>>>>> sumo-user mailing list >>>>>>> [email protected] >>>>>>> To unsubscribe from this list, visit >>>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>>> >>>>>> _______________________________________________ >>>>>> sumo-user mailing list >>>>>> [email protected] >>>>>> To unsubscribe from this list, visit >>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>> >>>>> _______________________________________________ >>>>> sumo-user mailing list >>>>> [email protected] >>>>> To unsubscribe from this list, visit >>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>> >>>> _______________________________________________ >>>> sumo-user mailing list >>>> [email protected] >>>> To unsubscribe from this list, visit >>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>> >>> _______________________________________________ >>> sumo-user mailing list >>> [email protected] >>> To unsubscribe from this list, visit >>> https://www.eclipse.org/mailman/listinfo/sumo-user >>> >> _______________________________________________ >> sumo-user mailing list >> [email protected] >> To unsubscribe from this list, visit >> https://www.eclipse.org/mailman/listinfo/sumo-user >> > _______________________________________________ > sumo-user mailing list > [email protected] > To unsubscribe from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
