> https://github.com/eclipse/sumo/issues/2110 According to https://sumo.dlr.de/docs/Simulation/Output/TripInfo.html#devices, do HBEFA models' drawbacks during deceleration, reflected in the CO2_abs, NOx_abs, ... characteristic values?
On Wed, May 4, 2022 at 10:18 AM Jakob Erdmann <[email protected]> wrote: > make sure to assign vClass "bus" to your bus: > <vType id="myBusType" vClass="bus"/> > <vehicle id="myBus" type="myBusType" .../> > > Am Di., 3. Mai 2022 um 20:31 Uhr schrieb ali mirzaei <[email protected] > >: > >> > You can change the junction type where the bus bay ends to "zipper" to >> ensure that the bus can merge. >> When I change the connection type to "zipper", other vehicles that used >> to move the side lane also enter the bus bay as shown in the attached >> picture. Trying to fix this by using "allow = bus" attribute for the bus >> bay, I faced another error says : " Vehicle 'bus_1' is not allowed to stop >> on lane 'e2_0'." >> [image: image.png] >> >> On Mon, May 2, 2022 at 4:51 PM Jakob Erdmann <[email protected]> >> wrote: >> >>> > the second problem still remains and bus can not re-enter the road >>> after the traffic volume increases >>> You can change the junction type where the bus bay ends to "zipper" to >>> ensure that the bus can merge. >>> >>> > I see that emission outputs reported "zero" for some vehicles while >>> they were on their way. >>> https://github.com/eclipse/sumo/issues/2110 >>> >>> Am Sa., 30. Apr. 2022 um 22:38 Uhr schrieb ali mirzaei < >>> [email protected]>: >>> >>>> I could insert the bus into its bay as you said and the emission >>>> outputs were recorded continuously. But, the second problem still remains >>>> and bus can not re-enter the road after the traffic volume increases. On >>>> the other hand, in some time steps, I see that emission outputs reported >>>> "zero" for some vehicles while they were on their way. >>>> >>>> >>>> On Sat, Apr 30, 2022 at 4:10 PM Jakob Erdmann <[email protected]> >>>> wrote: >>>> >>>>> startPos and pos must be in the range [0, 12] to stop on that edge. >>>>> The values always count from the start of the stop edge. >>>>> >>>>> Am Sa., 30. Apr. 2022 um 00:45 Uhr schrieb ali mirzaei < >>>>> [email protected]>: >>>>> >>>>>> I think I did so, didn't I? >>>>>> My startPos = 112.19 and the pos = 124.49 >>>>>> >>>>>> On Sat, Apr 30, 2022 at 2:31 AM Jakob Erdmann <[email protected]> >>>>>> wrote: >>>>>> >>>>>>> the lane for the bus bay is only 12m long. You'll have to set your >>>>>>> stop position within that range. >>>>>>> >>>>>>> Am Fr., 29. Apr. 2022 um 22:34 Uhr schrieb ali mirzaei < >>>>>>> [email protected]>: >>>>>>> >>>>>>>> I did what you said in my opinion but at the beginning of the >>>>>>>> simulation I faced the error : stop for vehicle 'bus_1' on lane 'e2_0' >>>>>>>> has >>>>>>>> an invalid position. Could you tell me what mistakes I have made? (I >>>>>>>> have >>>>>>>> attached my files for possible information required) >>>>>>>> >>>>>>>> >>>>>>>> On Fri, Apr 29, 2022 at 3:16 PM Jakob Erdmann < >>>>>>>> [email protected]> wrote: >>>>>>>> >>>>>>>>> The extra lane should only be as long as the bus bay and you'd >>>>>>>>> typically need to split the original edge into 3 parts to achieve >>>>>>>>> this. >>>>>>>>> >>>>>>>>> Am Fr., 29. Apr. 2022 um 12:37 Uhr schrieb ali mirzaei < >>>>>>>>> [email protected]>: >>>>>>>>> >>>>>>>>>> I added an extra lane and used it as a bus stop at the specified >>>>>>>>>> coordinates but before getting there, the bus makes a lane change >>>>>>>>>> from the >>>>>>>>>> upstream (which is not desired) and after the end of the stop >>>>>>>>>> period, it >>>>>>>>>> moves in the extra lane and no longer backs to its primary lane >>>>>>>>>> (which is >>>>>>>>>> not desired, too). >>>>>>>>>> >>>>>>>>>> On Fri, Apr 29, 2022 at 10:32 AM Jakob Erdmann < >>>>>>>>>> [email protected]> wrote: >>>>>>>>>> >>>>>>>>>>> 1. if a vehicle stops with attribute parking="true", it no >>>>>>>>>>> longer records emissions (up to the time where the stop ends and it >>>>>>>>>>> tries >>>>>>>>>>> to re-enter the network) >>>>>>>>>>> 2. if a vehicle returns from the "parking" state, road traffic >>>>>>>>>>> will generally not be are of it's wish to re-enter the road and >>>>>>>>>>> thus not >>>>>>>>>>> open a gap >>>>>>>>>>> >>>>>>>>>>> Both issues can be solved by modelling each bus bay with an >>>>>>>>>>> extra lane and having the bus stay on that lane during it's stop. >>>>>>>>>>> >>>>>>>>>>> Am Fr., 29. Apr. 2022 um 00:15 Uhr schrieb ali mirzaei < >>>>>>>>>>> [email protected]>: >>>>>>>>>>> >>>>>>>>>>>> Hi everyone, >>>>>>>>>>>> Using the ~.setStop() method, my buses start performing station >>>>>>>>>>>> operations where they were previously assigned. The emission class >>>>>>>>>>>> is >>>>>>>>>>>> "HBEFA3/PC_G_EU4". >>>>>>>>>>>> 1 - After observing some irregularities in the emission curves, >>>>>>>>>>>> I evaluated the emission outputs and found that at the moment the >>>>>>>>>>>> vehicle >>>>>>>>>>>> arrived at the station, the whole emission attributes turned to >>>>>>>>>>>> zero and >>>>>>>>>>>> after that no data of the vehicle was recorded for the duration >>>>>>>>>>>> length. >>>>>>>>>>>> This process stops when the vehicle leaves the station and the >>>>>>>>>>>> pollution >>>>>>>>>>>> information is recorded again. Why does this happen? >>>>>>>>>>>> 2 - When I add more vehicles to the road to simulate the rush >>>>>>>>>>>> hour effect on the operation, the merging of the bus would not >>>>>>>>>>>> happen in >>>>>>>>>>>> the determined period. How can I fix it? >>>>>>>>>>>> Best regards, >>>>>>>>>>>> Ali >>>>>>>>>>>> >>>>>>>>>>>> _______________________________________________ >>>>>>>>>>>> sumo-user mailing list >>>>>>>>>>>> [email protected] >>>>>>>>>>>> To unsubscribe from this list, visit >>>>>>>>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>>>>>>>> >>>>>>>>>>> _______________________________________________ >>>>>>>>>>> sumo-user mailing list >>>>>>>>>>> [email protected] >>>>>>>>>>> To unsubscribe from this list, visit >>>>>>>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>>>>>>> >>>>>>>>>> _______________________________________________ >>>>>>>>>> sumo-user mailing list >>>>>>>>>> [email protected] >>>>>>>>>> To unsubscribe from this list, visit >>>>>>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>>>>>> >>>>>>>>> _______________________________________________ >>>>>>>>> sumo-user mailing list >>>>>>>>> [email protected] >>>>>>>>> To unsubscribe from this list, visit >>>>>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>>>>> >>>>>>>> _______________________________________________ >>>>>>>> sumo-user mailing list >>>>>>>> [email protected] >>>>>>>> To unsubscribe from this list, visit >>>>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>>>> >>>>>>> _______________________________________________ >>>>>>> sumo-user mailing list >>>>>>> [email protected] >>>>>>> To unsubscribe from this list, visit >>>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>>> >>>>>> _______________________________________________ >>>>>> sumo-user mailing list >>>>>> [email protected] >>>>>> To unsubscribe from this list, visit >>>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>>> >>>>> _______________________________________________ >>>>> sumo-user mailing list >>>>> [email protected] >>>>> To unsubscribe from this list, visit >>>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>>> >>>> _______________________________________________ >>>> sumo-user mailing list >>>> [email protected] >>>> To unsubscribe from this list, visit >>>> https://www.eclipse.org/mailman/listinfo/sumo-user >>>> >>> _______________________________________________ >>> sumo-user mailing list >>> [email protected] >>> To unsubscribe from this list, visit >>> https://www.eclipse.org/mailman/listinfo/sumo-user >>> >> _______________________________________________ >> sumo-user mailing list >> [email protected] >> To unsubscribe from this list, visit >> https://www.eclipse.org/mailman/listinfo/sumo-user >> > _______________________________________________ > sumo-user mailing list > [email protected] > To unsubscribe from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
