If you can't ping your router, the problem isn't DNS, it's your basic network connection. Check the connection between your server and your router, and make sure you don't have a firewall or NAT configured.
The fact that you have the RUNNING flag set on your NIC is a good sign - it means you're plugged into something. But somehow that "something" isn't able to reach the router you want. Double-check your router's address also. -Bob On 05/18/11 01:05 PM, Kalle Anka wrote:
Bob, I now tried to setup /etc/resolv.conf on a fresh install of S11E, but still it dont work to get static ip. I added "dns" at the end: nsswitch.conf ... hosts: files dns ... I added the last line: resolv.conf nameserver 192.168.1.1 domain 195.54.122.200 Upon reboot, I can not ping 192.168.1.1. But I can ping 127.0.0.1. So how do I setup an /etc/resolv.conf file? Too bad that the SRS install instructions on the wiki doesn't work http://wiki.sun-rays.org/index.php/SRS_5.1_on_Solaris_11_Express When I get this working, I will post a how to how to install SRS v5.2 on a fresh S11E. Hopefully someone can update the install instructions. ------------------------ It sounds as though you did not set up your /etc/resolv.conf DNS control file? Can you do "ping 192.168.1.1"? That would verify whether your network connection itself is working. -Bob ----- Forwarded Message ---- From: Kalle Anka<[email protected]> To: [email protected] Sent: Wed, May 18, 2011 12:29:33 AM Subject: Fw: Install instructions of v5.2 for S11E? Ok, to install v5.2, Ive tried to first get static IP but did not succeed. I did these steps on my fresh installation of S11E: /etc/hosts 127.0.0.1 localhost loghost 192.168.1.3 Frasse /etc/hostname.e1000g0 Frasse netmask + broadcast + /etc/netmasks 192.168.1.0 255.255.255.0 /etc/defaultrouter 192.168.1.1 # cp /etc/nsswitch.dns /etc/nsswitch.conf # svcadm disable network/physical:nwam # svcadm enable network/physical:default Then I rebooted and I have no internet connection. Look: # netstat -rn Routing Table: IPv4 Destination Gateway Flags Ref Use Interface -------------------- -------------------- ----- ----- ---------- --------- default 192.168.1.1 UG 1 0 127.0.0.1 127.0.0.1 UH 2 4 lo0 192.168.1.0 192.168.1.3 U 2 0 e1000g0 Routing Table: IPv6 Destination/Mask Gateway Flags Ref Use If --------------------------- --------------------------- ----- --- ------- ----- ::1 ::1 UH 2 0 lo0 # ifconfig -a lo0: flags=2001000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4,VIRTUAL> mtu 8232 index 1 inet 127.0.0.1 netmask ff000000 e1000g0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2 inet 192.168.1.3 netmask ffffff00 broadcast 192.168.1.255 ether 0:1b:21:1e:2e:d0 lo0: flags=2002000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv6,VIRTUAL> mtu 8252 index 1 inet6 ::1/128 # ping www.google.com ping: unknown host www.google.com # getent hosts Frasse 192.168.1.3 Frasse What can be the problem? _______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users
_______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users
