Hi all. I managed to get the Iris mote to work with the IPBaseStation and blip driver, but quite a tricky way. I am using a mib520CA programmer for communication interface. When i plug the programmer in and attach the mote onto it the led2 will light. But when starting the driver on pc the led light goes off, or even before all flashes up then go off. After this using the programmer's reset switch does not seem to help, just detacthing and reattaching the mote. In this case the led2 turns on as default. I even tried doing this with disabling all the leds and just enable one specific led in the Boot.booted event. I always got the same result. After strarting blip driver, the mote halts, that means it does not reboot itself, and i can't do that either manually using reset switch. Now the tricky part. If i don't attach the mote to the programmer but start the blip driver on pc that tries to iniciate communication i wait for 1 or sec while the driver tries to initiate communication with the mote. Then i attach the mote and the blip is functioning properly. I can even login via telnet onto the mote and if i want to i can even reset the device using the programmer's reset switch. What can be so spoiled in the IPBaseStation that the mote does not accept even the hardware reset if the first (standard) case? The phenomenon can be reproduced using unmodified, official tinyos app IPBaseStation and blip driver. Have someone experiancing this reset problem? Does anybody have suggestions for solving this issue?
Regards Zsolt
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
