HI ALL ...
HI Zsolt , in my case the official IPBaseStation is itself not gettin
installed.
when i give "make iris install mib520,/dev/ttyUSB0" the errors appear
related to cc2420 interfaces and wirings associated with BaseStationP.nc ,
like in CC2420Config and CC2420ControlC.
can u suggest me what should i do? i thought like i should go for making
changes in BaseStationp.nc code , (i.e., changing cc2420's interfaces and
wirings to rf230's interfaces and wirings) BECAUSE, IRIS XM2110 DOESN'T HAS
CC2420, RATHER IT IS WITH RF230 RADIO.
If you think its some other way to the solution, then please send me the
IPBaseStation code (/opt/tinyos-2.x/apps/IPBaseStation) , atleast I'll check
it.
Regards,
Nithin keen
On Sun, Aug 29, 2010 at 2:04 AM, Miklos Maroti <[email protected]>wrote:
> miklos
>
>
> ---------- Forwarded message ----------
> From: Zsolt Szabó <[email protected]>
> Date: 2010/8/6
> Subject: [Tinyos-help] Blip on IRIS reset problem
> To: [email protected]
>
>
> Hi all.
>
> I managed to get the Iris mote to work with the IPBaseStation and blip
> driver, but quite a tricky way. I am using a mib520CA programmer for
> communication interface. When i plug the programmer in and attach the
> mote onto it the led2 will light. But when starting the driver on pc
> the led light goes off, or even before all flashes up then go off.
> After this using the programmer's reset switch does not seem to help,
> just detacthing and reattaching the mote. In this case the led2 turns
> on as default. I even tried doing this with disabling all the leds and
> just enable one specific led in the Boot.booted event. I always got
> the same result. After strarting blip driver, the mote halts, that
> means it does not reboot itself, and i can't do that either manually
> using reset switch. Now the tricky part. If i don't attach the mote to
> the programmer but start the blip driver on pc that tries to iniciate
> communication i wait for 1 or sec while the driver tries to initiate
> communication with the mote. Then i attach the mote and the blip is
> functioning properly. I can even login via telnet onto the mote and if
> i want to i can even reset the device using the programmer's reset
> switch.
> What can be so spoiled in the IPBaseStation that the mote does not
> accept even the hardware reset if the first (standard) case?
> The phenomenon can be reproduced using unmodified, official tinyos app
> IPBaseStation and blip driver.
> Have someone experiancing this reset problem? Does anybody have
> suggestions for solving this issue?
>
> Regards
> Zsolt
>
> _______________________________________________
> Tinyos-help mailing list
> [email protected]
> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
>
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
