Hi! Use the latest SVN vesrion of tinyos, not the one you have installed from tar/rpm.
Miklos On Mon, Aug 30, 2010 at 6:30 AM, nithin k n <[email protected]> wrote: > attached screenshots supports the problem statement what i reffered to... > > ---------- Forwarded message ---------- > From: nithin k n <[email protected]> > Date: Mon, Aug 30, 2010 at 9:53 AM > Subject: Re: [Tinyos-help] Blip on IRIS reset problem > To: [email protected], [email protected], > [email protected], Miklos Maroti <[email protected]> > > > HI ALL ... > HI Zsolt , in my case the official IPBaseStation is itself not gettin > installed. > when i give "make iris install mib520,/dev/ttyUSB0" the errors appear > related to cc2420 interfaces and wirings associated with BaseStationP.nc , > like in CC2420Config and CC2420ControlC. > > can u suggest me what should i do? i thought like i should go for making > changes in BaseStationp.nc code , (i.e., changing cc2420's interfaces and > wirings to rf230's interfaces and wirings) BECAUSE, IRIS XM2110 DOESN'T HAS > CC2420, RATHER IT IS WITH RF230 RADIO. > If you think its some other way to the solution, then please send me the > IPBaseStation code (/opt/tinyos-2.x/apps/IPBaseStation) , atleast I'll check > it. > > Regards, > Nithin keen > On Sun, Aug 29, 2010 at 2:04 AM, Miklos Maroti <[email protected]> > wrote: >> >> miklos >> >> >> ---------- Forwarded message ---------- >> From: Zsolt Szabó <[email protected]> >> Date: 2010/8/6 >> Subject: [Tinyos-help] Blip on IRIS reset problem >> To: [email protected] >> >> >> Hi all. >> >> I managed to get the Iris mote to work with the IPBaseStation and blip >> driver, but quite a tricky way. I am using a mib520CA programmer for >> communication interface. When i plug the programmer in and attach the >> mote onto it the led2 will light. But when starting the driver on pc >> the led light goes off, or even before all flashes up then go off. >> After this using the programmer's reset switch does not seem to help, >> just detacthing and reattaching the mote. In this case the led2 turns >> on as default. I even tried doing this with disabling all the leds and >> just enable one specific led in the Boot.booted event. I always got >> the same result. After strarting blip driver, the mote halts, that >> means it does not reboot itself, and i can't do that either manually >> using reset switch. Now the tricky part. If i don't attach the mote to >> the programmer but start the blip driver on pc that tries to iniciate >> communication i wait for 1 or sec while the driver tries to initiate >> communication with the mote. Then i attach the mote and the blip is >> functioning properly. I can even login via telnet onto the mote and if >> i want to i can even reset the device using the programmer's reset >> switch. >> What can be so spoiled in the IPBaseStation that the mote does not >> accept even the hardware reset if the first (standard) case? >> The phenomenon can be reproduced using unmodified, official tinyos app >> IPBaseStation and blip driver. >> Have someone experiancing this reset problem? Does anybody have >> suggestions for solving this issue? >> >> Regards >> Zsolt >> >> _______________________________________________ >> Tinyos-help mailing list >> [email protected] >> https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help > > > _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
