Please help! My Touch will not play through USB after upgrading to version 7.7.9.1, necessary to install the Spotty plugin.
My LMS is on a Windows 7 PC and was at version 7.7.5. The Touch was running the corresponding software version (I think 7.7.5 also) and EDO. It has worked perfectly with my DAC for a number of years. Never required any special settings. I downloaded and installed the 7.9.1 (August 2, 2017) server version. All good. The touch then updated to 7.8.0. Again good. At first the Touch was completely silent with the new version. The screen acted normally, bringing up the album art, progress bar, etc. Then the position counters immediately disappear and nothing happened. No sound from any of the outputs and no movement on the screen. But I noticed there was no "Digital Output" option in Settings. I went to the "Applet Installer" and found EDO 0.9 and installed. The Touch now responds and plays normally through the analog, coax, and toslink outputs. But still no sound out of USB, and when in USB mode the screen responds as described above. The Stop/Play control does not respond but the other controls all appear to work, while the Touch produces no sound. Going to the Web Remote Control on the server indicates mostly normal operation. It shows music streaming to the Touch, with progress bar and position counters working. But there is no sound from the Touch. The one problem is the same track repeats even though the Repeat option is not selected. I then decided to remove and reinstall the EDO kernel. I attempted to follow these instructions found on this site: -------------------------------------- To revert everything back to the original stage and factory defaults: - Power on the SBT - Hold down the little reset button on the back of the SBT just above the DC power plug for 10 seconds. This does the factory reset of the settings, but NOT of the installed Kernel ! - Let the SBT boot up to "Factory Settings". - Go to the Software Updating Menu (in settings, extended settings) - Force to "update" the Logitech Firmware - Let the SBT boot up completely. - Do another factory reset This procedure is copied from another website, if you search in the EDO threads there is also an uninstall procedure, -------------------------------------- The problem is, after booting to Factory Settings there is no "extended settings" but I assume "advanced" is what was meant. But there is no "force to update to Logitech firmware" option. The only option is to "Factory Reset" which does the same thing as the reset button. There is also a 'Software Update" option but that offers to revert to 7.7.8, not what I need. I also found the "Digital Output Kernel Update" option under Digital Output and ran it. Same results, no sound from USB. I have shut down everything and rebooted computer, LMS, DAC, and Touch numerous times and the problem persists. I searched EDO threads on this site and was not able to find anything helpful. I hope someone can help me get the USB output working again. Thanks Mark ------------------------------------------------------------------------ markbrauer's Profile: http://forums.slimdevices.com/member.php?userid=63564 View this thread: http://forums.slimdevices.com/showthread.php?t=94512 _______________________________________________ Touch mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/touch
